Engineering and Geoscience Professions Act s. 83.2

(1) No individual, corporation, partnership or other entity,
except a professional licensee (engineering), shall affix the stamp
or seal of a professional licensee (engineering) or allow that stamp
or seal to be affixed to a plan, drawing, detail drawing,
specification or other document or a reproduction of any of them
unless
(a) that plan, drawing, detail drawing, specification, other
document or reproduction was prepared by or under the
supervision and control of, and
(b) the stamp or seal is affixed with the knowledge and consen t
or in accordance with the direction of
the professional licensee (engineering) to whom the stamp or seal
was issued.
(2) Notwithstanding subsection (1), a professional licensee
(engineering) may affix a stamp or seal to a plan, drawing, detail
drawing, specification, other document or reproduction prepared by
other persons if the professional licensee (engineering) completes a
thorough review of and accepts professional responsibility for that
plan, drawing, detail drawing, specification, other document or
reproduction.
2007 c13 s14

MHHS Minimum Housing and Health Standards

83.2 Stamp or seal of professional licensee (engineering)